Convenient Wiring Tips for ZCEBOX Plastic Distribution Box Junction Boxes in Smart Home Scenarios

1. 1. Zoned Compatible Wiring for Smart Devices
2. Use ZCEBOX smart scenario dedicated partition kits (including weak current partition plates and signal isolation slots) to divide the box into "power supply area (5V/12V low-power supply)", "signal area (WiFi/Bluetooth control lines)" and "control area (gateway/controller wiring)" with a zone spacing of ≥3cm; select ZCEBOX integrated terminals with USB interfaces (supporting 5V/2A output) in the power supply area to directly power smart sensors and mini gateways, avoiding additional wiring; uniformly mark all smart device wires according to "black = power supply negative pole, white = signal transmission, red = power supply positive pole", and attach corresponding device labels next to terminals (e.g., "living room motion sensor") to quickly match devices and lines.
3. 2. Convenient Expansion + Signal Anti-Interference Optimization
4. Reserve 2 sets of spliceable expansion card slots in the box. When adding new smart devices later, directly install ZCEBOX quick-plug terminal modules (no need to remove original lines), suitable for ≤2.5mm² wires; prioritize ZCEBOX supporting shielded wires (anti-interference level ≥EMC Class B) for signal lines, keeping them away from strong current lines (distance ≥5cm) to avoid WiFi/Bluetooth signal interference; terminals adopt gold-plated contact design to reduce signal attenuation and ensure the response sensitivity of smart devices, while supporting hot swapping (under power-off state) for convenient device replacement and maintenance.

E-mail: sales@zcebox.com